0
  • DE
  • EN
  • FR
  • Base de données et galerie internationale d'ouvrages d'art et du génie civil

Publicité

Effect of Fibre Orientation on the Bond Properties of Softwood and Hardwood Interfaces

Auteur(s):
ORCID
ORCID
ORCID
Médium: article de revue
Langue(s): anglais
Publié dans: Buildings, , n. 4, v. 13
Page(s): 1011
DOI: 10.3390/buildings13041011
Abstrait:

Increasing concerns regarding carbon emissions and climate change are prompting a shift toward the use of sustainable materials in the construction industry. Engineered timber products are gaining attention in the construction industry due to advancements in lamination techniques and adhesives as well as the renewable characteristics of wood. Bond properties play a significant role in engineered timber products. In Australia, Radiata Pine (RP, softwood) and Shining Gum (SG, hardwood) share a large proportion of local and native plantation forest resources. The present paper investigates the bond behaviours of Australian softwoods (RP–RP), hardwoods (SG–SG) and hybrid-wood (RP–SG) combinations in both parallel (PAL) and perpendicular (PER) bonding directions using one-component polyurethane adhesives. The results indicate that most of the softwood samples were subjected to wood-side (timber) failure, whereas hardwood samples failed due to delamination but exhibited higher strength and stiffness regardless of bond direction. In contrast, bond direction had a significant effect on the bond characteristics of hybrid configurations. Improved bond properties were observed when bonded in PAL directions; however, negative effects were seen when bonded in PER directions. Obtained characteristic (5th percentile) shear bond strengths for RP–RP–PAL, RP–SG–PAL and SG–SG–PAL samples were 3.88 MPa, 6.19 MPa and 8.34 MPa, whilst those for RP–RP–PER, RP–SG–PER and SG–SG–PER samples were 3.45 MPa, 2.96 MPa and 7.83 MPa, respectively.

Copyright: © 2023 by the authors; licensee MDPI, Basel, Switzerland.
License:

Cette oeuvre a été publiée sous la license Creative Commons Attribution 4.0 (CC-BY 4.0). Il est autorisé de partager et adapter l'oeuvre tant que l'auteur est crédité et la license est indiquée (avec le lien ci-dessus). Vous devez aussi indiquer si des changements on été fait vis-à-vis de l'original.

  • Informations
    sur cette fiche
  • Reference-ID
    10728446
  • Publié(e) le:
    30.05.2023
  • Modifié(e) le:
    01.06.2023
 
Structurae coopère avec
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine